NOTE:

Due to the shipping reason, We’ll ship the kit in pieces, not an assembled set, and doesn’t contain batteries.
It is used the 18650 3.7V battery.
We can provide tutorials, programming code, and instructions. PLEASE LEAVE YOUR EMAIL ADDRESS TO US!

Imagine if you have a robot that has a camera on board and can be controlled through the >> Internet. It would open a lot of opportunities for using it.

For example, you could send the robot to the kitchen to check if you accidentally left the kettle on the stove!

I found that with ESP32-CAM it can be done easily.

The ESP32-CAM is a very small camera development board with an ESP32-S chip, an OV2640 camera, a microSD card slot, and several GPIOs to connect peripherals.

The OV2640 is a 1/4-inch CMOS UXGA (1632*1232) image sensor.

The sensor’s small size and low operating voltage provide all the features of a single UXGA camera and image processor.

Packing List

1 × Black acrylic robot chassis
1 × L298N Motor Drive Module
4 × 5V DC geared motor (with wheels welding wire)
1 × 18650 battery box with switch
1 × ESP32 Cam development board with OV2640 camera module
10 × M3*15 copper pillar
4 × DuPont female to female 20cm
2 × Dupont line male to female 20cm
4 × Motor fixing bracket
16 × M3*10 flat head screws
8 × M3*12 flat head screws
24 × M3 nuts
8 × M3*30 round head screws
2 × M1.6*10 screws
2 × M1.6 nut
4 × M3*8 flat head screws
1 × ESP32(CAM) Car Kit
3 × PE foam sponge double-sided adhesive, strong and high-viscosity foam adhesive (white 24.5*40mm)
1 × Blue driver heat sink small (TMC2100)
1 × ESP32 motherboard shell (black)
1 × Ultrasonic bracket