Description

EleksMana SE V3.2 2-axis Control Board XY axis with Case CNC Laser Engraver Controller Stepper Motor Driver Controller Board

 

Specifications:

• Brand EleskMaker
• Model ManaSE
• Interface USB
• Size 94*46mm
• Hole Size 85x36mm
• Support Axis XY axis
• Power Requirement Higher than12V 2A
• Support Stepper Motor Motor within 2A 2-phase 4-wire
• Input Voltage 12V
• Power Interface DC5.5 – 2.1  (Inside is positive  electrodes and
• outside is negative electrodes)

 

 

Features:

1. Fit for DIY desktop laser engraver,dispensing machines printer,plotter
2. Come with USB cable and connector wires.
3. 2-axis  linkage Y-axis dual interface, can drive a stepper motor within 2A 2-phase 4-wire.
4. Large MOS tube,on board DC buck module, jumper  ADJ can adjust manually the laser voltage to control the laser power
Tips:
EleksCAM software download link is here : http://wiki.eleksmaker.com/doku.php?id=elekscam
Note:
There isn’t  Voltage Regulator Module in this  Laser board .
The motor can not  work higher  than 2A, when the motor work for a long time in 1A to 2A , please pay attention to heat
Wiring instruction:

Package included:
1 X  2 Axis Driver Board
1 X USB Cable
5 X Connector Wire