Advantage

1. Launch delay, scanning protection, good heat dissipation

2. Highly compact and sealed housing,

3. Easy to install, adjust the project Angle by loosening and tightening the fixing screw.

Electrical Parameters

AC 110~240V wide voltage input; Plug type: US, EU, UK, and AU

The Whole Package

The whole set includes: 1pcs RGB laser module together with modulation board, 1pcs 120V~240Vac input 12Vdc output power supply. (include 1 pair 10cm red and black color cables.)

Modulation (Analog/Off Defaulted)

There is a modulation switch for changing the modulation mode between Analog and TTL, the default factory mode is “Analog Modulation” and the inside indicator LED is in GREEN color; if the modulation is changed to TTL, the LED will be in RED color. The laser is defaulted NON-WORKING in factory mode, it means the laser will not give off light after we connect the whole set to the AC source, the laser only gives off lights after receiving modulation signal.

Integrated RGB laser module

All the diodes are installed inside the chamber, and the optical roads are not easily to be contaminated.

Important Notice

NEVER try to increase the output current of any laser diode by rotating the adjustable resistor on the modulation board, all the diodes are nearly driven by their full powers, and the over driving will burn the diodes in only 0.5~2 seconds.